Star Micronics SP200F SERIES Manuel d'utilisateur télécharger pdf (Page 45)

PARTS REPLACEMENT

4-5

4.7 Print Head

1. Turn off the power switch, disconnect the power cord

from wall outlet.

2. Remove

• Upper case unit(not shown in the figure)according

to the procedure described in Section 4.1.

• Two screws 1

• Head cover 2

• Two tapping screws 3

• Head cable 4

• Print head 5

WARNINGWARNING

WARNING

The print head becomes hot after printing so wait

for it to cool before removing it.

3. Adjust

• Gap between print head and platen

(Refer to Section 3.2.)

• Column displacement for bi-directional printing

(Refer to Section 3.3.)

4.8 Drive Shaft Unit

1. Remove

• Upper case unit according to the procedure des-

cribed in Section 4.1.

• Print head according to the procedure described

in Section 4.7.

• One screw 1 (Ribbon Base)

• Ribbon base (not shown in the figure)

• One screw 2 (Ribbon shaft guide 3 )

• Stop ring 4

• Paper feed clutch unit 5

• Stop ring 6

• Gear 7

• Stop ring 8

• Drive shaft gear L 9

• Clutch claw gear ;

• Stop ring A

• Drive shaft bearing B

• Stop ring C

• Carriage guide stay D

• Worm gear E

• Drive shaft unit F

2. Adjust

• Column displacement

Refer to Section 3.3.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 89 90

Commentaires sur ces manuels

Pas de commentaire

Star Micronics SP200F SERIES Manuel d'utilisateur Page 45

Commentaires sur ces manuels

Produits connexes et manuels pour Imprimer et scanner Star Micronics SP200F SERIES