Star Micronics Multi-Font XR-1020 Manuel d'utilisateur télécharger pdf (Page 100)

Select g-pin graphics mode

Mode ASCII

Decimal

Hexadecimal

Std.

<ESC> “N n0 nl

27 94 n0 nl

10 5E n0 nl

n2 ml m2 . . .

n2 ml m2

. . . n2 ml m2 . . .

Selects one of eight graphics modes depending on the value of n0

and prints g-pin bit-image graphics in this mode. The graphic image

is 9 dots high and nZ + n2 x 256 dots wide.

n0 Graphics mode

0 Normal-density

1 Double-density

2 Double-density, double-speed

3 Quadruple-density

4 CRT graphics, mode I

5 Plotter graphics

6 CRT graphics, mode II

7 Double-density plotter graphics

( 60 dots per inch)

(120 dots per inch)

(240 dots per inch)

( 80 dots per inch)

( 72 dots per inch)

( 90 dots per inch)

(144 dots per inch)

Maximum width is 8 inches for normal carriage printer, and 13.6

inches for wide carriage printer. ml, m2, . . . are byte pairs repre-

senting 9 vertical dots each.

In the leftmost position, the most significant bit of ml is the top dot;

the least significant bit of ml is the second dot from the bottom; the

most significant bit of m2 is the bottom dot; and the other bits of m2

are ignored. Other byte pairs are similar. The number of data bytes

must be 2 x (nl + n2 x 256). Dots beyond the right margin are

ignored. At the end of bit-image printing the printer returns auto-

matically to character mode.

J -

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 109 110

Pas de commentaire

Star Micronics Multi-Font XR-1020 Manuel d'utilisateur Page 100