Star Micronics TSP2000 Manuel d'utilisateur télécharger pdf (Page 21)

– 17 –

ENGLISH

(4)Position the roll paper straight and close the printer cover gently.

Note 1: Make sure that the paper is positioned straight. If the printer cover

is closed with the paper skewed, a paper jam may result.

Note 2: Lock the printer cover by pressing on the center of the cover. If any

part of the cover other than the center is pressed, the cover may not

be locked properly. This may sometimes disable printing.

(5)Set the power switch to on to turn on power to the printer. Make sure that the

ERROR LED is not lit.

Note: While the ERROR LED is lit, the printer will not accept any commands

such as the print command, so make sure that the printer cover is locked

properly.

7-3. Releasing a Locked Cutter

If the auto cutter locks up or fails to cut the paper, follow the steps below.

Caution

Since working on the cutter may be dangerous, be sure to turn off the printer first.

(1)Set the power switch to OFF to turn off the printer.

(2)Slide off the front cover to reveal the auto cutter.

(3)Remove any jammed paper.

Note: Be careful not to damage the printer while removing any jammed

paper.

Since the thermal print head is particularly sensitive, be sure not to

touch it.

Auto cutter

Front cover

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 102 103

Pas de commentaire

Star Micronics TSP2000 Manuel d'utilisateur Page 21