Star-micronics Parallel Interface Unit IP-NPC Manuel d'utilisateur télécharger pdf (Page 5)

English

• First remove the printer cover by pushing in the tabs located on both

sides of the lower rear of the printer with a screwdriver as illustrated

below.

• Connect the ribbon cable to the top terminal inside the printer, and

carefully slide the parallel interface unit into the printer.

After sliding the interface unit in as far as it will go, secure it in place

with the two large screws that come with it.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Pas de commentaire

Star-micronics Parallel Interface Unit IP-NPC Manuel d'utilisateur Page 5