THERMAL RE-WRITABLECARD READER / WRITERTCP300 SERIES• User’s Manual •This ‘User’s Manual’ describes important information to enable you to usethe read
– 8 –<Settings for Communication Speed>To change the serial communication settings, change the following DIP switch settings.(Ex-factory Default
– 9 –5-2 USB Interface<Mounting the USB Interface Cable>1. Connect one end of the interface cable to the reader/writer and the other end to theh
– 10 –6. Interface Board Replacement (RS-232C to USB)Replacement Procedures1. Turn off the power switch. Then, unplug the power cord from the outlet.
– 11 –7. Cleaning CardsA cleaning card is used to clean the transport rollers inside the unit. Two cleaning cardsaccompany each unit. They are in th
– 12 –8. Troubleshooting• Trouble when Turning on the PowerSymptom Possible Cause What to DoThe power indicator Won’t accept The power plug is not Cor
– 13 –• Removing Jammed Cards1. Turn off the power and unplug the reader/writer.2. Press the cover opener.3. Lift the upper cover while the cover is o
– 14 –9. General Specifications Item SpecificationsCard Specification PET (Thin type card)Card Transport Unit Transport Method RollersCard Insertion D
Federal Communications CommissionRadio Frequency Interference StatementThis equipment has been tested and found to comply with the limits for a Class
– 1 –1. Precautions for Safe UseCarefully read and obey the following items to prevent injury to yourself or to othersand to prevent damaging property
– 2 – Precautions for Reader/Writer Use1. Use only Star recommended cards.The reader/writer and the card may not operate normally if other cards are
– 3 –10. In case of reader/writer error (abnormal sounds, abnormal odors, smoke, fire) turn offthe reader/writer immediately and unplug it from the po
– 4 –2. General DescriptionThe TCP300 series reader/writers are equipped with a thermal type display mechanismon a PET(Polyethyleneterephtalate) ma
– 5 –3. UnpackingThe following outlines the reader/writer and its accessories.The reader/writer (TCP300 Series)1. Reader/writer2. Cleaning cards (2 ca
– 6 –4. External Appearance and Part NamesThe reader/writer (TCP300 Series)1. Power Switch ... This turns the power to the re
– 7 –5. Connect to and Setting External Devices5-1 RS-232C Interface<Mounting the RS-232C Interface Cable>1. Cut the power to the host computer
Commentaires sur ces manuels